Page 1 of 1

Little Pullip on Obitsu 11cm?

PostPosted: Sun Nov 20, 2011 11:44 am
by Kirahfaye
I purchased a lovely Little Seine and want to put her on an articulated body. Easiest would be the 11cm Obitsu body that I have. However I'm worried about trying to pull the Pullip head off her body without ruining it. Anyone do this before? Ideas, comments, suggestions, tutorials - all would be welcome!

Re: Little Pullip on Obitsu 11cm?

PostPosted: Sun Nov 20, 2011 12:04 pm
by AlmySidaKay
Some of the older Little Pullip's have a screw in the back of their head under their hair that keeps their head together. I put my Little Pullip on a 27cm body, but it should work the same way.

Re: Little Pullip on Obitsu 11cm?

PostPosted: Sun Nov 20, 2011 8:42 pm
by richila

Re: Little Pullip on Obitsu 11cm?

PostPosted: Mon Nov 21, 2011 1:08 pm
by Evelien
Instead of dewigging your Little Pullip, you can loosen up the wig at the front or the back only, and lift it up just far enough to reach the screw in the back. Once you're done you can glue it down again :)

Re: Little Pullip on Obitsu 11cm?

PostPosted: Tue Feb 14, 2012 3:02 pm
by Kirahfaye
Okay, so I followed the instructions on that page - but my Seine seems to have a larger neck hole than the washer. Suggestions?

Re: Little Pullip on Obitsu 11cm?

PostPosted: Tue Feb 14, 2012 4:12 pm
by richila
Cut a bigger washer out of craft foam. :D

Re: Little Pullip on Obitsu 11cm?

PostPosted: Tue Feb 14, 2012 4:41 pm
by Greyhaunt
Or you can use thick plastic to cut out a new washer, like those gallon milk and water jugs. Those are my favs :)