Iwa_Hoshi wrote:Because I keep forgetting even when I see them.
I like to know if
- Obitsu 50cm can wear the Volks MDD victory hands or is Obi50 better off with a pair of Victory hands for DDs instead?
Okay, Back at Home! Where are those parts bins...Piiiiiiiiiiinkyyyyyy! Come heeeeereeeee!
The MDD hands will fit the 50cm but the "hand paddle" (the part that's in the hand, not the ball joint) of the wrist part is very small and the MDD hand will just fall off. The structure Volks uses inside the hand is much larger than its Obitsu 50cm counterpart. Some eye putty or other such material that fills the void would remedy this. Of course you could do something more permanent like epoxy putties.
DD2 hands are definitely too large.
And can the MDD wear
- the wrist joint of Obi50 (with or without modding?)
The MDD and 50cm wrist parts are very similar in overall size, shape, and parts layout. The 50cm wrist ball even fits nicely in the end of the MDD forearm vinyl. However, the peg on the wrist part of the 50cm is a much larger diameter than the MDD, a little over a millimeter. So you would have to reduce the diameter for it to fit in the MDD elbow joint forearm socket.
- Obi50's hands with/without the Obi wrists
The 50cm hands are much smaller at the wrist than the MDDs. Quite a bit of material would have to be removed from the 50cm hand.
Pinky's MDD hands are fit on 60cm wrist parts, modded to fit 50cm elbow parts.
Remember, if you are going to do any modifications with MDD and 50cms, try to work it out so you are modding the 50cm part, NOT the MDD part. 50cm parts are available for purchase, MDD internal parts are not.
Posted: Thu May 26, 2011 9:00 am