I have scraps and left overs cut from jewelry making sheet metal, I'm guessing 20-24 gauge? It's thin and flexible like soda cans. The stuff you can get at the craft store for dapping.
I'm looking for a way to reuse the bits, can this metal be heated up a bit to soften and hammer several small pieces together or will it melt? This would definitely be an outside project with precautions and tools.
Sheet metal/dapping questions
4 posts
• Page 1 of 1
Re: Sheet metal/dapping questions
by zirconmermaid » Mon Apr 15, 2013 6:07 pm
Without significant heat, I don't think it would melt. It depends on what the metal content is. http://www.kitco.com/jewelry/meltingpoints.html This is a link to melting points.
It's all about Hazel!
"Space.... the Vinyl Frontier. These are the voyages of the Starship Obitsurprise. Her 1/3rd scale mission: To seek out new plotlines, to explore the Whole Apartment - To Ball-Jointedly go where no doll has gone before!" -- Swan
Avatar by Meredith Dillman, http://www.meredithdillman.com
"Space.... the Vinyl Frontier. These are the voyages of the Starship Obitsurprise. Her 1/3rd scale mission: To seek out new plotlines, to explore the Whole Apartment - To Ball-Jointedly go where no doll has gone before!" -- Swan
Avatar by Meredith Dillman, http://www.meredithdillman.com
-
zirconmermaid - It's all about Hazel
- Posts: 3316
- Joined: Sat Mar 20, 2010 6:28 pm
- Location: Hazel's House, in Minnesota
Re: Sheet metal/dapping questions
by E-Beth » Mon Apr 15, 2013 9:36 pm
It could become brittle with heating and cooling.
You could use something like JB Weld (2 part epoxy for metals).
You could use something like JB Weld (2 part epoxy for metals).
-
E-Beth - I snort dolliehs liek candi
- Posts: 377
- Joined: Mon Jul 16, 2012 2:07 pm
- Location: Northern California, east of Sacramento
Re: Sheet metal/dapping questions
by DollyKim » Thu Apr 18, 2013 6:38 am
Mkay, thanks. I don't have the packaging any more so I'm not entirely sure what it is, just the thin sheets you can get at the craft store. And I've heard of JB Weld, I'll look in to that too.
Maybe putting the bits in clear resin to make OOAK jewelry bits might be better.
Maybe putting the bits in clear resin to make OOAK jewelry bits might be better.
-
DollyKim - Dr. Dollittle
- Posts: 7790
- Joined: Sat Mar 20, 2010 3:07 pm
- Location: At the base of Mt Baldy
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests